Kenmore Series 200 Washer Triple Action Agitator Manual (2024)

FAQs

How to reset Kenmore series 200 washing machine? ›

RESET - Rotate cycle selector knob counterclockwise to clear sequence. a. Rotate cycle selector knob counter-clockwise one full rotation and the control panel should beep.

If the washer won't agitate, replacing the agitator repair kit may solve the problem. The kit contains the agitator components that are most likely to wear out and/or fail. If any of the parts are worn out, stripped, or damaged, replace the kit.

If your washer is plugged into an outlet, simply unplug the unit for one minute and then plug the unit back in. If the washer is hard-wired to the power supply, turn the breaker off at the home electrical panel that powers the washer for one minute and then turn the breaker back on.

If your washer won't agitate but spins, a broken agitator may be to blame. The agitator is the centerpiece in a top load washer that agitates and moves the clothes through the water during the wash cycle. The output shaft of the transmission is splined to the agitator to secure it in place.

If the washer drum is not spinning or agitating, and is making a clicking or grinding noise, the actuator may be faulty. The rotor position sensor monitors the direction and speed of the spinning rotor and communicates this information to the electronic control board.

Check for a broken agitator

Open the washer lid. Remove the fabric softener dispenser or top cover of the agitator. Try to manually—and gently—turn the agitator, which should provide resistance if it's intact.

The agitator could come off the base if not seated properly. It can easily be snapped back in place: Line up the grooves in the agitator auger with the agitator base. Turn counter-clockwise until it locks into place.

Can you remove the agitator from a washing machine? It is not recommended to remove the agitator from most washing machines, and if your washing machine has a built-in agitator, it is needed to clean your clothes. It's also not necessary to remove it to clean it.

Check the magnets on the inside edge of the rotor for damage and replace the rotor if you find broken magnets. Check the wire harness connections between the electronic control board and the drive motor. Reconnect any loose wires or replace the wire harness if it's damaged.

How do you reset the error on a washing machine? ›

Some washing machines have a reset function, consult your manual for details. Also, reset by disconnecting from power for a few minutes. Open and close the door of the machine 6 times within 12 seconds for a master reset. Before a reset, check power, circuit breaker, child lock, drain house or adjust the load.